open cast mining,open pit mining,mining information,mining

YOU CAN REEFER TO THE LINKS ABOVE AND SIDE OF THE PAGE FOR EXTRA INFORMATION

Open-pit mining, or opencast mining, refers to a method of extracting rock or minerals from the earth by their removal from an open pit or borrow.

The term is used to differentiate this form of mining from extractive methods that require tunneling into the earth. Open-pit mines are used when deposits of commercially useful minerals or rock are found near the surface; that is, where the overburden (surface material covering the valuable deposit) is relatively thin or the material of interest is structurally unsuitable for tunneling (as would be the case for sand, cinder, and gravel). For minerals that occur deep below the surface—where the overburden is thick or the mineral occurs as veins in hard rock— underground mining methods extract the valued material.

Open-pit mines that produce building materials are commonly referred to as quarries. People in some English-speaking countries are unlikely to make a distinction between an open-pit mine and other types of open-cast mines, such as quarries,borrows, placers, and strip mines.

Open-pit mines are typically enlarged until either the mineral resource is exhausted, or an increasing ratio of overburden to ore makes further mining uneconomic. When this occurs, the exhausted mines are sometimes converted to landfills for disposal of solid wastes. However, some form of water control is usually required to keep the mine pit from becoming a lake.

Extraction


Open Cut mines are dug on benches, which describe vertical levels of the hole. These benches are usually on 4 meter to 60 meter intervals, depending on the size of the machinery being used. Many quarries do not use benches, as they are usually shallow.

Most walls of the pit are generally dug on an angle less than vertical, to prevent and minimise damage and danger from rock falls. This depends on how weathered the rocks are, and the type of rock, and also how many structural weaknesses occur within the rocks, such as a fault,shears, joints or foliations.


The walls are stepped. The inclined section of the wall is known as the batter, and the flat part of the step is known as the bench or berm. The steps in the walls help prevent rock falls continuing down the entire face of the wall. In some instances additional ground support is required and rock bolts, cable bolts and shotcrete are used. De-watering bores may be used to relieve water pressure by drilling horizontally into the wall, which is often enough to cause failures in the wall by itself.



A haul road is situated at the side of the pit, forming a ramp up which trucks can drive, carrying ore and waste rock.

Waste rock is piled up at surface near the edge of the open cut. This is known as the waste dump. The waste dump is also tiered and stepped, to minimise erosion.

Ore which has been processed is known as tailings, and is generally a slurry. This is pumped to a tailings dam or settling pond, where the water evaporates. Tailings dams can often be toxic due to the presence of unextracted sulfide minerals, some forms of toxic minerals in the gangue, and often cyanide which is used to treat gold ore via the cyanide leach process.

Open-pit coal mining at Garzweiler, Germany

Rehabilitation

After mining finishes, the mine area must undergo rehabilitation. Waste dumps are contoured to flatten them out, to further stabilise them. If the ore contains sulfides it is usually covered with a layer of clay to prevent access of rain and oxygen from the air, which can oxidise the sulfides to produce sulfuric acid. This is then generally covered with soil, and vegetation is planted to help consolidate the material. Eventually this layer will erode, but it is generally hoped that the rate of leaching or acid will be slowed by the cover such that the environment can handle the load of acid and associated heavy metals. There are no long term studies on the success of these covers due to the relatively short time in which large scale open pit mining has existed. It may take hundreds to thousands of years for some waste dumps to become "acid neutral" and stop leaching to the environment. The dumps are usually fenced off to prevent livestock denuding them of vegetation. The open pit is then surrounded with a fence, to prevent access, and it generally eventually fills up with ground water. In arid areas it may not fill due to the deep groundwater levels.



Typical open cut grades

Gold is generally extracted in open cut mines at 1 to 2 ppm (grams per ton) but in certain cases, 0.75ppm gold is economic. This was achieved by bulk heap leaching at Alkane Minerals Ltd. Peak Hill mine in western New South Wales, near Dubbo.
Nickel, generally as laterite, is extracted via open cut down to 0.2%. Copper is extracted at grades as low as 0.15% to 0.2%, generally in massive open cut mines in Chile, where the size of the resources and favorable metallurgy allows economies of scale.

Materials typically extracted from open-pit mines include:

  • Clay
  • Coal
  • Coquina
  • Diamonds
  • Gravel and stone (stone refers to bedrock, while gravel is unconsolidated material, as found in glacial or fluvial deposits)
  • Granite
  • Gritstone
  • Gypsum
  • Limestone
  • Marble
  • Metal ores, such as copper, iron, gold, and molybdenum
  • Oil shale
  • Sand
  • Sandstone
  • Slate

Open-pit mines


The Lavender Pit, Bisbee, Arizona

Australia

  • Super Pit – gold mine near Kalgoorlie, Western Australia.
  • Cadia mine; gold and copper mine located near Orange, New South Wales.

Canada

  • Adams Mine – controversial abandoned mine in Kirkland Lake, Ontario.
  • Colomac Mine– gold mine in Northwest Territories, Canada.
  • Diavik Diamond Mine – diamond mine in Northwest Territories, Canada.
  • Ekati Diamond Mine – diamond mine in Northwest Territories, Canada.
  • Pine Point Mine – lead and zinc mine in Northwest Territories, Canada.

Chile

  • Chuquicamata – Chilean copper mine; the second largest open-pit copper mine in the world.
  • Escondida copper mine
  • Pascua Lama – gold and silver mine in Atacama, Chile (in project)
  • Radomiro Tomic copper mine

Colombia

  • Cerrejón – coal mine in Guajira Department.

Indonesia

  • Grasberg mine– the largest gold mine and the third largest copper mine in the world located in the mountains of the Papua province.

Kyrgyzstan

  • Kumtor Gold Mine – gold mine in Tian Shan Mountains at 4,000-4,400 m (14,000 ft) above sea level.

Mongolia

  • href="http://bBoroo Gold Mine – gold mine 110 km (70 mi) WNW of the capital Ulan Bator.

Namibia

  • Rossing – uranium mine.

Portugal

  • Sao Domingos Mine– copper mine.

Russia




The Udachnaya pipe in Russia.
  • Mirny Mine− diamond mine in Mirny, Eastern Siberia
  • Udachnaya pipe − diamond mine in Yakutia, Russia.

South Africa

  • The Big Hole, a diamond mine in Kimberley, South Africa that reaches a depth of more than 1,000 m (3,300 ft).

United Kingdom

  • Penrhyn Quarry – slate quarry in Wales.

United States

  • Berkeley Pit - former copper mine in Butte, Montana; now a toxic lake and tourist attraction.
  • El Chino Mine – copper mine in Grant County,New Mexico.
  • Hull-Rust-Mahoning Mine – largest open pit iron mine in the world near Hibbing, Minnesota.
  • Bingham Canyon Mine – largest excavation in the world; copper mine in Salt Lake County, Utah.
  • Lavender Pit – copper mine in Cochise County, Arizona.
for Information on underground moning visit
www.undergroundmining.blogspot.com




Free Search Engine Submission thanks to: Create a Website